BMW fault code 0008

Telematic Control Unit (I bus)

In the telematic control unit (i bus), code 0008 means different things depending on the version of the module in the car. Find your car below; the app shows the right one for yours.

BIT: Activation wire DSP, short circuit to positive

Module version: Basis Interface Telephone (BIT)

In: 3 Series (E46) 1998–2006, 5 Series (E39) 1998–2003, 7 Series (E38) 1998–2001, X5 (E53) 1999–2006, Z8 (E52) 2000–2003

BIT: DSP signal, short circuit to positive

Module version: Basis Interface Telephone (BIT2)

In: 3 Series (E46) 1998–2006, 5 Series (E39) 1998–2003, 7 Series (E38) 1998–2001, X5 (E53) 1999–2006, Z8 (E52) 2000–2003

Emergency switch short

Module version: Telephone USA (TEL_US)

Which BMWs have this version depends on the engine and equipment, so we don't list them here; AutoLingo for BMW reads which version your car has.

Reading and clearing it

Fault code 0008 is a BMW code, stored in the car's telematic control unit (i bus), not a generic OBD2 code (P0xxx): a generic OBD2 reader only reaches the engine's emissions faults, so it won't show it. AutoLingo for BMW reads it with BMW's own diagnostic protocols, in plain English, with the details the module stored about it, and clears it after a repair. If a fault comes right back after it's cleared, the problem is still there.

The telematic control unit (i bus) is on: 7 Series (E38), 5 Series (E39), 3 Series (E46), Z8 (E52), X5 (E53), X3 (E83), Z4 (E85), Z4 (E86)

← 0007 All telematic control unit (i bus) fault codes 0009 →